Radio frequency inactivation of Salmonella Typhimurium and Listeria monocytogenes in skimmed and whole milk powder.

Milk powder is a convenient, shelf-stable food ingredient used in a variety of food products. However, pathogenic bacteria can be present and survive during prolonged storage, leading to outbreaks of foodborne diseases and product recalls. Radio frequency (RF) heating is a processing technology suitable for bulk treatment of milk powder, aiming at microbial inactivation. This study investigates the RF inactivation of Salmonella Typhimurium and Listeria monocytogenes in two types of milk powder; skimmed and whole milk powder. Specifically, the aims were to (i) examine the influence of the powder's composition on bacterial inactivation, (ii) evaluate the response of bacteria with different Gram properties (Gram positive and Gram negative) and (iii) verify the use of Enterococcus faecium as a surrogate for the two microorganisms for the specific RF process. In order to examine exclusively the influence of RF, a non-isothermal temperature profile was used, employing solely different RF energy levels to heat the product to the target temperatures. A log-linear model with a Bigelow-type temperature dependency was fitted to the experimental data. S. Typhimurium was less susceptible to RF treatments in comparison to L.monocytogenes, demonstrating a higher inactivation rate (k) and higher percentage of sublethal injury. A higher k was also observed for both microorganisms in the whole milk powder, indicating that the increased fat content and decreased levels of lactose and protein in the milk powder had an adverse impact on the microbial survival for both pathogens. The surrogate microorganism E. faecium successfully validated the microbial response of the two microorganisms to RF treatments. In general, a low heating rate RF-only process was successful in inactivating the two foodborne pathogens in skimmed and whole milk powder by 4 log(CFU/g).

Influence of microbial cell morphology and composition on radio frequency heating of simple media at different frequencies.

The effect of Listeria monocytogenes, Salmonella Typhimurium, and Saccharomyces cerevisiae on RF heating was studied in sterilized Milli-Q water and saline solution during treatments at 27.0 ± 0.6 MHz and 3.0 ± 0.02 MHz for 30 min. The presence of microorganisms caused a significant increase in temperature (maximum to 54.9 °C), with no significant decrease in cell numbers being observed for any conditions. For both media and frequencies, heating rates followed the order S. Typhimurium ≤ L. monocytogenes ≤ S. cerevisiae, except for heating at 3.0 ± 0.02 MHz in saline solution, where heating rates for S. cerevisiae and S. Typhimurium were equal. Generally, heating rates for microorganisms were significantly higher at 27.0 ± 0.6 MHz than at 3.0 ± 0.02 MHz, except for the S. cerevisiae case. Observed phenomena were probably caused by differences in the cell lipid and peptidoglycan content, with interaction effects with salt being present. This study was the first to investigate the influence of the presence of microorganisms on heating behavior of simple media. On the long term, more research on this topic could lead to finding specific RF frequencies more suitable for the heating of specific media and products for various applications.

Non-electrolytic synthesis of copper oxide/carbon nanocomposite by surface plasma in super-dehydrated ethanol.

Electrolytic processes are widely used to synthesize different nanomaterials and it does not depend on what kind of the method has been applied (wet-chemistry, sonochemistry, plasma chemistry, electrolysis and so on). Generally, the reactions in the electrolyte are considered to be reduction/oxidation (REDOX) reactions between chemical reagents or the deposition of matter on the electrodes, in line with Faraday's law. Due to the presence of electroconductive additives in any electrolyte, the polarization effect of polar molecules conducting an electrical current disappears, when external high-strength electric field is induced. Because initially of the charge transfer always belongs of electroconductive additive and it does not depend on applied voltage. The polarization of ethanol molecules has been applied to conduct an electric current by surface plasma interaction for the synthesis of a copper oxide/carbon nanocomposite material.